AMT Datasouth Fastmark M3 - Handbuch (Seite 27)

~ 27 ~
Dump Mode printout
The printer will enter dump mode after printing the configuration page. In the
dump mode, all characters will be printed in 2 columns as following. The left side
characters are received from your system and right side data are the
corresponding hexadecimal value of the characters. It allows users or engineers
to verify and debug the program exceptions.
 Dump mode requires 3 ” wide paper width setting.
 Turn OFF / ON the power to resume printer for normal printing.
(Ready mode)
Printer Initialization
Printer initialization is used to clear DRAM and restore printer settings to defaults.
Printer initialization is activated by the following procedures.
1.
Turn off the printer power.
2.
Hold on the FEED button then turn on the power button
3.
Release the power button when the LED color turns
amber, continue pressing the FEED button.
4.
Release the FEED button when the LED indicates
and blinking. The LED will sequence right to left, 5 blinks each.
5.
Printer configuration will be restored. Refer to next page for default list.
ASCII Data Hexadecimal Data