Clearaudio Double Matrix Professional Sonic - Handbuch (Seite 6)

Double Matrix Professional
Sonic
page /Seite 6  clearaudio electronic GmbH 2015
User manual
Bedienungsanleitung
3. Set-up of the Double Matrix Professional Sonic
Take the already assembled Double Matrix Professional Sonic record cleaning machine from its
packaging. Set it on a stable and horizontal surface (such as a desk or rack).
Please note that due to the weight of the record cleaning machine, the feet of the device can cause
marks on soft surfaces. Due to the warm air outlet on the bottom of the
Double Matrix Professional
Sonic, the surface on which it rests should be heat resistant to a minimum of 60°C.
3.1 Connect to the mains supply
To avoid using an additional extension cable, place the Double Matrix Professional Sonic within
2 metres of an electrical wall outlet.
Connect the supplied mains cable first to the IEC socket on the back of the
Double Matrix Professional
Sonic , and then to the electrical wall outlet.
Press the switch on the IEC socket and position it to “I”.
Using the funnel supplied, fill the cleaning fluid reservoir with cleaning fluid. Pay careful attention to
the fluid level LED indicator to avoid over-filling. For best results we recommend using Clearaudio Pure
Groove cleaning fluid. Close the cleaning fluid reservoir with the cap.
Now the Double Matrix Professional Sonic is ready for use. Please read the whole user manual before
cleaning your first record.
Note: Voltages are referenced to EU countries with 230V mains power.
In other countries the mains voltage and frequency may vary (e.g. USA 115V/60Hz.)
The correct operating voltage can be found on the back of the device on the product information label (Fig. 1).
The mains cable supplied should be of the type appropriate for your country. Please ensure that the
mains voltage of your country also matches the mains voltage of the device. This information is also on
the product information label (see above). If it does not match, contact your Clearaudio dealer.
Fig. 1: Product information label on the back