Denon DN-X100 - Handbuch (Seite 9)

9
ENGLISH
5 FADER START
If the separately sold DN-S5000, DN-S3000, DN-S1000 and etc. players are connected to FADER PGM1 or
PGM2, they can started using the Channel fader or Crossfader, as long as the 3.5 mm stereo mini cords have
been connected.
R R MODEL NO.
MADE IN JAPAN FABRIQUE AU JAPO
DN-S1000 R R DELE NO. DEL NO.
BPM
PLAY/PAUSE
BRAKE
TAP
PRESET
CONT. /SINGLE
MEMO
RVS
FLANGER
RANGE PITCH BEND
0
A1 B A2
CLR
FLIP
DISC EJECT
CUE
BRAKE
TAP
PRESET
CONT.
TIME
/SINGLE
MEMO
RVS
DISC MODE
FILTER
FLANGER
A1
RELOOP EXIT/
A2
CLR
FLIP
1-MIN. SKIP
DISC EJECT
R L R L FADER
FADER
PGM1
FADER
PGM2
LINE2
LINE
OUT
LINE
OUT LINE4
FADER
DN-X100
FADER
PGM2
FADER
PGM1
FADER FADER
(1)-2, 5 (1)-2, 5
(2)-2, 5
(1)-1
(2)-4 (1)-4
(1)-1
(1)-4
(2)-1 (2)-1
Channel Fader Start
Turn on the CH 1/2 FADER
START switches
@8.
1
2
Crossfader Start
NOTES:
• When the CROSS FADER REVERSE switch is
set to ON, the Crossfader's operating direction is
reversed.
• Channel Fader Start and Crossfader Start for the
same source will not operate simultaneously.
You must select from either one. If both CH
FADER START and CROSSFADER START A, B
switches are ON, priority will be the Crossfader.
Move the Channel fader !3 of
CH-1 or CH-2 control all the
way to the bottom.
3 Set the standby mode on CD player.
5
When you want to start the
player, move up the Channel
fader
!3 and the CD player
will begin playing.
1
2
Slide the Crossfader !4 all the way in direction
opposite the source you want to start. (In the
following example, startup is done with the CD
player connected to PGM1.)
5
When the Crossfader !4 is slid in the opposite
direction, CD player play will begin.
CD player (DN-S1000) CD player (DN-S1000)
4
Use the CH 1/2 FADER
CONTOUR controls
#1 to
control the Channel fader
startup curve.
NOTE:
• When the CH 1/2 FADER REVERSE switch is set
to ON, the corresponding fader's operating
direction is reversed.
Turn on the CROSSFADER START A, B
switches
@9.
3 Set the standby mode on CD player.
4
Use the CROSS FADER
CONTOUR control
#3 to
control the Crossfader
startup curve.