CEJN System P8 - Handbuch (Seite 13)

11 1 mm +-
13
For further QUESTIONS & ANSWERS, please go to www.cejn.com/P8
GB
2.2 Bus plate, 16 933 0097
Connect the bus plate as follows:
5
4
3
2
1
1 2
3 4
5
A 7-pin connector is supplied
with the CEJN P8 multi-
coupling.
Hot fluid IN to the bus goes to
the nipple located nearest to the
upward protruding guide on the
multi-coupling. It is colour-coded
RED and is marked IN. The nipple
(the male connector) has an inside
G 1/2” thread which fits the 16 mm
(5/8”) or 19 mm (3/4”) hose adapters
supplied.
A starter inhibitor sensor, which is a
PNP type (normally closed) inductive
sensor, is supplied separately and must
be fitted at a distance of 11±1 mm from
the plate, as illustrated in the diagram.
Compressed air goes to a CEJN 320
type nipple which has a relief valve.
The spacer must be fitted on the
front of the plate. The connection of
the nipple has an inner G 1/4” thread
which fits the 10 mm (3/8”) hose
adapter supplied.
Return fluid exits from the BLUE colour-
coded nipple marked OUT. The nipple
(the male connector) has an inside G 1/2”
thread which fits the 16 mm (5/8”) or
19 mm (3/4”) hose adapters supplied.