System setup – Denon AVR-1306 Benutzerhandbuch
Seite 14
ENGLISH
11
System Setup
ENGLISH
Use System Setup to customize a variety of settings to suit your listening environment.
For the contents of a system menu and the initial setting of this unit (
page 16).
• You can change the settings using the buttons on the remote control unit.
• The AVR-1306 is equipped with an alpha numeric front panel display that can also be used to check and adjust settings. Some
representative front display examples are shown below.
CURSOR
MODE 1
SETUP
ENTER
Front display
System Setup
No.
* T E S T T O N E Y e s <
Press the CURSOR
F
F button to execute.
Currently selected line
* C O A X 1 C D
Current setting
Currently selected line
1
Set the
MODE 1
switch to “AUDIO”.
2
Press the
SETUP
button to enter the setting.
4
Press the
ENTER
or
CURSOR H
H
button to confirm
the new settings.
* S y s t e m S e t u p
3
Press the
ENTER
or
CURSOR H
H
button to select
the setting, then press the
CURSOR F
F
or
G
G
button to select the parameter.
* F r o n t L a r g e
Large
Small
* C e n t e r S m a l l
Large
Small
None
5
Press the
SETUP
button to finish system set up.
[ Display ]
Setting the Speaker Configuration
1
Press the
CURSOR F
F
or
G
G
button to select your
front speaker type, then press the
ENTER
or
CURSOR H
H
button to switch to the center speaker
setting.
* F r o n t L a r g e
Large
Small
2
Press the
CURSOR F
F
or
G
G
button to select your
center speaker type, then press the
ENTER
or
CURSOR H
H
button to switch to the surround
speaker setting.
* C e n t e r S m a l l
Large
Small
None
When “Small” has been selected for the front speakers,
“Large” cannot be selected for the center speaker.
3
Press the
CURSOR F
F
or
G
G
button to select your
surround speaker type, then press the
ENTER
or
CURSOR H
H
button to switch to the subwoofer
setting.
* S u r r . S m a l l
Large
Small
None
When “Small” has been selected for the front speakers,
“Large” cannot be selected for the surround speakers.
The composition of the signals output to each channel and the
frequency response are adjusted automatically according to the
combination of speakers actually being used.