Denon AVR-1306 - Handbuch (Seite 22)

ENGLISH
19
Basic Operation Basic Operation
ENGLISH
2 Input mode display
• In the AUTO mode
• In the DIGITAL PCM mode
• In the DIGITAL DTS mode
• In the ANALOG mode
Depending on the input signal.
2 Input signal display
• DOLBY DIGITAL
• DTS
• PCM
The “DIGITAL” indicator lights
when digital signals are being input
properly. If the “DIGITAL” indicator
does not light, check whether the
Digital In Assignment setup (
page 15) and connections are correct
and whether the component’s
power is turned on.
NOTE:
• The “DIGITAL” indicator will light when playing CD-ROMs
containing data other than audio signals, but no sound will
be heard.
Playing audio sources (CDs and DVDs)
2-channel playback modes
• The AVR-1306 is equipped with 2-channel playback modes
exclusively for music.
• Select the mode to suit your tastes.
Press the DIRECT/STEREO button on the main unit
or the DIRECT button on the remote control unit to
select the DIRECT mode.
2 DIRECT mode
Use this mode to achieve good quality 2-channel sound while
watching images. In this mode, the audio signals bypass such
circuits as the tone circuit and are transmitted directly, resulting
in good quality sound.
Press the DIRECT/STEREO button on the main unit
or the STEREO button on the remote control unit to
select the STEREO mode.
2 STEREO mode
Use this mode to adjust the tone and achieve the desired sound
while watching images.
Surround
SELECT
DIRECT/STEREO
SURROUND PARAMETER
STANDARD
ENTER
STANDARD
DIRECT
SURROUND
PARAMETER
CURSOR F CURSOR G
STEREO
Dolby Pro Logic II mode
1 Press the STANDARD button to select the Dolby
Pro Logic II mode.
• The Dolby Pro Logic II indicator lights.
Lights
2 Play a program source.
For operating instructions, refer to the manuals of the
respective components.
The mode switches as shown below each time the button
is pressed.
DTS NEO:6 DOLBY PL II
3 Press the SURROUND PARAMETER button to
select the surround parameter mode.