Silvercrest SKATG 1050 A1 - Handbuch (Seite 6)

- 4 -
Setting the Time
• Press the button PROG a once, so that CLOCK
appears in the display t .
• Repeatedly press the button HOUR o for hours,
resp. the button MIN i for minutes, until the correct
time is programmed in. If you hold the buttons
down, the numbers run through faster.
• Press the button PROG a twice. The time
display is now programmed,
or
• if you do not press any other button for ca. 10
seconds, the indicator CLOCK extinguishes in
the display
t and the time is programmed.
Making coffee
• Open the lid w .
• Using the measuring spoon, place coffee powder
(coarse to medium ground) into the filter q .
A level measuring spoon of coffee approximates
to ca. 6 gr of coffee powder.
Note:
Should you use finely ground coffee powder it
could block the filter q , water can no longer flow
through it and the coffee maker could overflow!
• Fill the water tank e with the required amount
of water. For this, use the glass jug l with the
scale. When filling the appliance with water, never
exceed the MAX marking in the water tank
e .
• Close the lid w .
Note:
After brewing, there is always somewhat less coffee
in the glass jug
l than the amount of water that
you filled the water tank e with. The coffee powder
absorbs some of the water.
• Place the glass jug l in the coffee maker.
• Press the button ON/AUTO/OFF s once.
The red indicator lamp y glows. The coffee maker
begins the brewing process.
• When the brewing process is complete, the coffee
is kept warm by the keep-warm plate r for two
hours. On the expiry of this period the coffee
maker switches itself.
• Should you wish to switch the coffee maker off
earlier, repeatedly press the button
ON/AUTO/OFF
s until the indicator lamps y /
u are extinguished.
Risk of scalding!
After the brewing process the coffee machine must
first cool down, for at least 10 minutes, before you
start another brew. If you do not, there is a risk of
being scalded by escaping steam!
Coffee servings
With this coffee maker you can fill a cup with coffee
using only one hand:
• When there is coffee in the glass jug
l , press
and hold your cup against the coffee button d .
Coffee flows into the cup.
• When the cup is full, remove the cup from the
coffee button d .
• Any drips that might fall will be caught by the
driptray grill f .
Note:
Regularly empty and clean the driptray under the drip-
tray grill
f . Otherwise, it could overflow.
Note:
If you pour coffee using the coffee button d , a
small amount of coffee will always be left in the
glass jug
l .
You can also pour coffee from the glass jug l in
the usual manner:
• Lift the glass jug
l and then pull it to the front.
IB_61863_SKATG1050A1_LB3 09.11.2010 14:33 Uhr Seite 4