Electrolux T37850 - Handbuch (Seite 49)

3. Remove foil hose and polystyrene pad-
ding from the machine.
Fitting the vent hose
To simplify the installation, there is a choice of vent outlets: one at the back, the others in
the left and right-hand side. Connect the hose to whichever is the more convenient by
pulling the ring nut (A) from the vent outlet at the back, screwing it on to the hose and
pushing it firmly back into place. The unused vents should now be sealed with the special
snap covers provided.
If the hose is long and the room temperature low,
the moisture might condense to water inside the
hose. This is an unavoidable natural phenomenon.
To prevent this water from Iying in the hose or
flowing back into the tumble dryer, it is advisable
to drill a small hole (via. 3 mm) in the lowest point
of the hose and to place a small container below
it. (See picture, point B).
Once connected to the dryer, run the vent hose to
the desired outlet point, ensuring that the run’s
overall length is less than 2 m, and that it contains
no more than two bends. As to the outlet itself, if
you have decided on a fixed wall/window grille, a
good local builder’s merchant should be able to
supply you with the necessary fittings and installation advice.
Installation 49