Electrolux T37850 - Handbuch (Seite 50)

WARNING!
It is important not to connect the vent hose to, for
example, a cooker hood, or a chimney or flue pipe
designed to carry the exhaust from a fuel burning
appliance.
Note that to avoid condensation problems, it is
essential that the dryer be fitted with the flexible
hose to carry its “exhaust” at least beyond the
kitchen units; preferable outside the kitchen. In
order to prevent the appliance from overheating,
it is important that the steam exhaust is unob-
structed. Therefore, in case of a permanent hose
fitted to an exterior wall or ceiling, it must be en-
sured an exhaust capacity of at least 150 m3/h. If
the dryer is fitted next to kitchen units, make sure that the vent hose is not squashed. If
the hose is partially squashed, drying efficiency will be reduced, resulting in longer drying
times and higher energy consumption. If the hose is completely squashed, the safety cut-
outs with which the machine is fitted may operate. When operating the tumble dryer, the
room temperature must not be lower than +5°C and higher than +35°C, as it may affect
the performance of the appliance.
Electrical connection
Details on mains voltage, type of current and the fuses required should be taken from the
type plate. The type plate is fitted near the loading aperture (see “Product description”
chapter).
Connect the machine to an earthed socket, in accordance with current wiring reg-
ulations.
WARNING!
The manufacturer declines any responsibility for damage or injury through failure
to comply with the above safety precautions.
Should the appliance power supply cable need to be replaced, this must be carried
out by our Service Center.
WARNING!
The plug must be accessible after installing the machine.
Changing door stop
WARNING!
Before changing the door stop, disconnect the mains plug.
50 Installation