Marmitek AWM2 - Handbuch (Seite 7)

• Install the wall switch at its original place after the MicroModule is
programmed.
Programming
WARNING: DO NOT FORGET TO TURN ON THE MAIN MASTER SWITCH
PRIOR TO PROGRAMMING.
Activate the setup mode.
The following steps have to be taken to start the setup procedure for
programming the MicroModule:
• Press the setup (prog.) button for at least 3 seconds (see figure 5).
The LED should stay on after releasing the setup button.
• Warning! The MicroModule will leave the setup mode if it doesn’t
receive any commands within 60 seconds.
Exit setup mode
• Press the setup button once shortly; The red LED will turn off now.
You can also wait for at least 60 seconds so that the MicroModule
will exit the setup mode automatically.
prog.
SAIX
prog.
SAIX
MICROMODULE AWM2 7