Marmitek AWM2 - Handbuch (Seite 9)

For programming the Marmitek X10 address and options you will be
able to use any Marmitek X10 controller or remote control. For the
following explanation we used a Marmitek 8-in-1 remote control to
program the preferred settings (When you use an RF remote control
like the Marmitek 8-in-1, then a TM13 Plug-in Transceiver is required
to convert the RF signals to the X10 commands on the power line).
Sample 1. Program the Marmitek X10 address E4:
• Setup your remote control (see manual 8-in-1) and the TM13
transceiver to house code E.
• Start with the MicroModule in setup mode.
• Press the Marmitek X10 button (marked with the symbol of a
house) of the 8-in-1 remote control and then press button 4.
• Press the "ON" button 2x (= channel+).
• The MicroModule responds by blinking the LED twice.
• The address E4 is programmed.
Sample 2. Program the function "All Units Off"
• Make sure you program the required Marmitek X10 address first!!
(e.g. E4).
• Leave the remote control and the TM13 Transceiver on HouseCode
E or set it to the right HouseCode.
• Start with the MicroModule in setup mode.
• Press button marked with "All Units Off" 2x (= mute).
• The MicroModule responds by blinking the LED 8x.
NOTES:
• When you program the MicroModule, always program the address
first the optional function second.
• If the MicroModule receives a new address during setup mode, the
optional functions will be automatically reset to the factory
defaults.
MICROMODULE AWM2 9