Sterling Power Products PS1208 - Handbuch (Seite 10)

AC Power and Charging LED Status Indicators
The ProSport includes two LED indicators as shown below.
Green “AC Power” LED indicator:
When on, the green LED indicates that AC power is present.
Red “Charging” LED indicator
When on, the red LED indicates that the batteries are in the multi-stage charging mode. When charging is
complete, only the green “AC Power” LED will remain on.
L.E.D. information
Green on = Power on
Red on = High charge on
Red off = Battery full, on float
10 11
14
13
12
11
14.6V
13.3V
Charging Conditioning Maintenance / Float Mode
Average Voltage
Vo
lts
Multi-Stage Charging Overview
When the ProSport charger is turned on, the green AC power indicator will turn on followed by the red
charging LED indicator.
The multi-stage charger will provide the following:
ProSport Charging
During this mode the ProSport will use ist available charging amps (as controlled by temperature) until the
battery voltage is raised to 14.6V DC (lead-acid factory setting).
ProSport Conditioning
The ProSport will hold batteries at 14.6V DC (factory set for lead-acid batteries) to complete charging while
conditioning batteries by desulfating each battery connected. Upon completion the ProSport will go into float
mode.
3. Float / Maintenance Mode
During this mode the red “Charging” LED will turn off, indicating that the charging process is over and that the
charger is now maintaining your batteries on-board. Only the green LED will remain on, indicating “Power On /
Float-Maintenance Mode”.
This is a precision 13.3 volts (lead-acid factory setting) finishing voltage that maintains each battery, perfect
for short or long storage periods and never overcharging your batteries (step down voltage regulation mode).
Note: The only LED indicator that will we on during the float mode will be the green “Power On” LED indicator.
Owner's Periodic Maintenance Guide
Item: Battery Connections
Process: Clean and tighten all battery connections. Follow battery manufacturer’s instructions
for cleaning a battery. Clean all battery terminals with a wire brush where required
and tighten all battery connections.
When: Monthly
Item: Battery Electrolyte
Process: Per battery manufacturer’s instructions monitor and maintain proper levels of
distilled water in each battery.
When: Monthly
Item: ProSport DC Output Wiring
Process: Visually inspect all wiring for cuts and abrasions.contact Sterling Power Products if
charger needs to be serviced with new wiring.
When: Monthly
Item: AC Power Cord and Mounting Hardware Inspection
Process: Visually inspect the AC power cord. Confirm ground blade is present and plug
blades are in good condition and not bent out of place.
Check all mounting hardware to ensure there is no loose hardware. Tighten where
required.
When: Monthly