Start/pause – Zanussi ZWH6140P Benutzerhandbuch

Seite 17

Advertising
background image

7

Start/Pause

e

z

u

a

P

/

t

r

a

t

S

e

s

u

a

P

/

t

r

a

p

é

D

Start the programme by pressing the button 7

• To start the selected programme, press the button 7, the

corresponding green pilot light stops flashing. The pilot light
6.1 illuminates to indicate that the appliance starts operat-
ing and the door is locked. If you have chosen a delayed
start, the appliance will begin the countdown.

• To interrupt a programme which is running, press the but-

ton 7: the corresponding green pilot light starts flashing. It
is possible to change some options of a running pro-
gramme before the programme carries them out.

• To restart the programme from the point at which it was in-

terrupted, press the button 7.

• After the programme has started the door is locked. If, for

any reason, you need to open the door, set firstly the ap-
pliance to PAUSE by pressing the button 7. After a few mi-
nutes it will be possible to open the door.
If the door remains locked, this means that the appliance is
already heating or that the water level is too high. In any
case, do not try to force the door!
If you cannot open the door but you need to open it you
have to switch the appliance off by turning the selector dial
to

. After a few minutes the door can be opened (pay

attention to the water level and temperature!). After
closing the door, it is necessary to select the programme
and options again and to press the button 7.

At the end of the programme

The appliance stops automatically. The pilot
light of the button 7 and the pilot light corre-
sponding to the just finished washing phase go
off. The light 6.3 illuminates.
If a programme or an option that ends with wa-
ter left in the tub has been selected and the
door remains locked to indicate that the water
must be emptied out before opening the door.
Follow the below instructions to empty out the
water:

• Turn the programme selector dial to

.

• Select the draining or spinning programme.

• Reduce the spin speed if needed, by press-

ing the relevant button.

• Press the button 7.
At the end of the programme, the door can be
now opened. Turn the programme selector dial
to

to switch the appliance off.

Remove the laundry from the drum and carefully
check that the drum is empty. If you do not in-
tend to carry out another wash, close the water
tap. Leave the door open to prevent the forma-
tion of mildew and unpleasant smells.

Warning! If there are children or pets in
the house, activate the child safety de-

vice in the inner side of the door frame (for
more details read " Child safety" in the chapter
"Safety Information").

Stand by: during programme setting up
and once the programme has finished, if

the programme selector dial and any button are
not touched, after a few minutes the energy
saving system is enabled. The pilot lights go off.
The green pilot light of the button 7 flashes with
a low frequency. By pressing any button the
appliance will come out of the energy saving
status.

17

www.zanussi.com

Advertising