Zanussi ZWH6140P Benutzerhandbuch
Seite 8
Positioning and levelling
x 4
Level the appliance by raising or lowering the
feet.
The appliance MUST be level and stable on a
flat hard floor. If necessary, check the setting
with a spirit level. Any necessary adjustment
can be made with a spanner.
Accurate levelling prevents vibration, noise
and displacement of the appliance during op-
eration.
Repeat the levelling action, if the appliance is
not level and stable.
Water inlet
Connect the hose to
a tap with a 3/4”
thread.
35°
45°
Loosen the ring nut to angle the hose to the
left or right depending on the position of your
water tap. Do not place the inlet hose
downwards. After positioning the inlet hose,
be sure to tighten the ring nut again to pre-
vent leaks.
Water drainage
Firstly form a hook in the end of the drain
hose using the plastic hose guide supplied
with the appliance .
The end of the drain hose can be positioned
in four ways:
• Hooked over the edge of a sink using
the plastic hose guide.
8
www.zanussi.com