Zanussi ZDI112X - Handbuch (Seite 11)

2. Press the delay start button.
– The delay start indicator light comes on.
3. Press the start/cancel button.
– The countdown of the delay start starts.
– The phase indicator lights go off.
When the countdown is completed, the washing pro-
gramme automatically starts.
• The delay start indicator light goes off.
• The phase indicator light comes on.
Do not open the door during the countdown to pre-
vent interruption of the countdown. When you close
the door again, the countdown continues from the point
of interruption.
Cancelling a delay start:
1. Press and hold the start/cancel button for approxi-
mately 5 seconds.
– The start/cancel indicator light and delay start in-
dicator light go off.
– The phase indicator lights start to flash.
2. Press the start/cancel button to start the washing
programme.
End of the washing programme
Switch off the appliance in these conditions:
• The appliance stops automatically.
• The end indicator light comes on.
For better drying results, keep the door ajar for some mi-
nutes before you remove the dishes.
Let the dishes cool down before you remove them from
the appliance. Hot dishes are easily damaged.
Removing the load
• First remove items from the lower basket, then from
the upper basket.
• There can be water on the sides and door of the appli-
ance. Stainless steel becomes cool more quickly than
the dishes.
Care and cleaning
Warning! Switch the appliance off before you clean
the filters.
Cleaning the filters
Important! Do not use the appliance without the filters.
Make sure that the installation of the filters is correct.
Incorrect installation will cause unsatisfactory washing
results and damage to the appliance.
1 2
Fully clean the filters A, B
and C below running wa-
ter.
3
To remove filters B and C,
turn the handle approxi-
mately 1/4 anticlockwise.
4
Remove the flat filter A
from the bottom of the ap-
pliance.
11