What to do if – Zanussi ZDI112X Benutzerhandbuch

Seite 12

Advertising
background image

5

Put the flat filter A in the

bottom of the appliance.

Install the flat filter cor-

rectly under the two

guides D.

6

Put the filter system in po-

sition. To lock the filter

system, turn the handle

clockwise until it locks in

position.

Important! Do not remove the spray arms.

If the holes in the spray arms become clogged, remove

remaining parts of soil with a cocktail stick.

External cleaning

Clean the external surfaces of the appliance and control

panel with a damp soft cloth. Only use neutral detergents.

Do not use abrasive products, scouring pads or solvents

(acetone, trichloroethylene etc...).

Frost precautions

Caution! Do not install the appliance where the

temperature is below 0 °C. The manufacturer is not

responsible for damage because of frost.
If not possible, empty the appliance and close the door.

Disconnect the water inlet hose and remove water from

the water inlet hose.

What to do if…

The appliance does not start or stops during operation.

If there is a fault, first try to find a solution to the problem

yourself. If you cannot find a solution to the problem

yourself, contact the Service Force Centre.

Fault code and malfunction

Possible cause and solution

• continuous flash of the start/cancel in-

dicator light

• 1 flash of the end indicator light

The dishwasher does not fill with water

• The water tap is blocked or furred with limescale.

Clean the water tap.

• The water tap is closed.

Open the water tap.

• The filter in the water inlet hose is blocked.

Clean the filter.

• The connection of the water inlet hose is not correct. The hose can

be kinked or squashed.

Make sure that the connection is correct.

• continuous flash of the start/cancel in-

dicator light

• 2 flashes of the end indicator light

The dishwasher will not drain

• There is a blockage in the sink spigot.

Clean the sink spigot.

• The connection of the water drain hose is not correct. The hose can

be kinked or squashed.

Make sure that the connection is correct.

• continuous flash of the start/cancel in-

dicator light

• 3 flashes of the end indicator light

The anti-flood device operates

• Close the water tap and contact your local Service Force Centre.

12

Advertising