Xoro HSD 7799 - Handbuch (Seite 74)

ENG-34
HSD 7799
Engl
ish
Move to Installation and press OK, then a submenu shall be popped up which includes three
options:
x
Auto Scan
x
Channel Scan
Auto Scan
Scan Mode: Free (scan all free channels), All
(scan all channels including free and paid ones);
Search: Press OK to display Scan box and
conduct auto scan, or press SETUP or EXIT to
quit. The scan box indicates the scan process by
percentage of completion; On the top there is
details about Scan Band, Frequency,
Demodulation mode, Channel No, Transmission
mode and Guard Interval etc.; Below are the
scanned TV channels and radio channels
displayed in two columns.
Channel Scan
x
Scan Mode: By Channel and By
Frequency. Either alternative shall be fine
for scan.
x
Scan Band: VHF/ UHF available.
x
Ch No. : Channel 5~12 ( VHF), and
Channel 21~69 (UHF)
x
Frequency: 174~230 MHz (VHF),
470~862 MHz (UHF) are available.
(The frequency system can be set
automatically according to different
regions, and the actual frequency point
should be referred to the practice).
x
Band Width: There are three options: 6
MHz, 7 MHz, and 8 MHz.
x
Search: Move the cursor here and
press OK, then a information box shall
appear indicating the scanning process.
Pressing Exit allows you to cancel scan
and quit current interface. The scan
process box shows the progress of
scan by percentage of completion; On
the top there is detail about Scan Band, Frequency, Demodulation modes, Channel No,
Transmission mode and Guard Interval etc.; Below are the scanned TV channel list and
radio channel list displayed in two columns.
Notes:
1.
Only when Scan Mode is set to “By Channel”, can Scan Band and Ch No be ready for setup.
2. Only when Scan Mode is set to “ By Frequency”, can Frequency and Band Width be set.
DVB-T Setup