Xoro HRS 8520 - Handbuch (Seite 73)

HRS 8520 19
Engl
ish
First steps
1. Single connection of dish and receiver
The satellite dish is aligned to a special satellite and you use one or multiple LNBs. Each LNB is
directly connected to the satellite receiver.
After choosing the satellite make sure that only
following parameters are defined:
LNB Type:
09750/10/600
LNB voltage: 13/18V
22KHz: AUTO
Tonebust: None
DiSEqC 1.0: None
DiSEqC 1.2: None
Motor: None
LNB voltage
The LNB for digital programs is usually supplied with 13 and 18V. The option is automatically 13/18V.
The voltage can be changed manually. This directly influences the search results. Possible options
are: OFF, 13V, 18V and 13/18V. If the option OFF is activated the LNB is not
supplied with power any more which inflicts that no programs can be received any more.
22 kHz
By using the 22 kHz signal combined with a universal LNB it is possible to receive the whole ASTRA-
satellite system (analog & digital) with a single 60cm satellite dish. For receiving digital TV and radio
only a Set-Top-Box is needed.
The digital TV programs are all arranged in the higher frequency band -> use the option AUTO
The remaining options are explained in the following configuration steps.
Press the BLUE key to start the program search
run.
A new menu appears asking for more
parameters. Define them as follows
Search mode: Standard, Blind, Network
Encrypted:
All channels, Free channels
Service Type: All, TV, Radio
Channel Search