Zanussi ZBF11420SA - Handbuch (Seite 10)

x
x
If necessary cut the adhe-
sive sealing strip and then
apply it to the appliance as
shown in figure.
1
2
Install the appliance in the
niche.
Push the appliance in the
direction of the arrows (1)
until the upper gap cover
stops against the kitchen
furniture.
Push the appliance in the
direction of the arrows (2)
against the cupboard on the
opposite side of the hinge.
44mm
4mm
Adjust the appliance in the
niche.
Make sure that the distance
between the appliance and
the cupboard front-edge is
44 mm.
The lower hinge cover (in
the accessories bag) makes
sure that the distance be-
tween the appliance and the
kitchen furniture is correct.
Make sure that the clear-
ance between the appliance
and the cupboard is 4 mm.
Open the door. Put the low-
er hinge cover in position.
I
I
Attach the appliance to the
niche with 4 screws.
Remove the correct part
from the hinge cover (E).
Make sure to remove the
part DX, in the case of right
hinge, SX in opposite case.
E
E
D
C
Attach the covers (C, D) to
the lugs and the hinge
holes.
Attach the hinge covers (E)
to the hinge.
Ha Hb
Hd Hc
Disconnect the parts (Ha),
(Hb), (Hc) and (Hd).
21 mm
21 mm
~50 mm
~50 mm
90 o
90 o
Install the part (Ha) on the
inner side of the kitchen
furniture.
10