WolfVision VZ-9.4F User Manual - Handbuch (Seite 12)

Shooting Area Outside of the Working Surface
Eliminating reflections
In order to eliminate reflections (on high gloss photographs etc.) just turn
the light upwards or downwards slightly (default position is horizontal).
It is also possible to move the document and rotate the camera head to
the center of the desired pick-up area to eliminate reflections.
The curvature of the working plate is specially designed to eliminate
reflections.
Please note that reflections can also be caused by general room lighting
conditions.
Shooting Area on the Working Surface
Close-up adaptor lens
For shooting an object outside of the working surface, the close up lens
(#8) has to be tipped up. It is impossible to remove the lens completely
from the unit and therefore it cannot get lost.
When using the Visualizer to record on the working surface again, put the
close up lens back to its original position.
The camera can be tilted by 290° (110° to the speaker and 180° to the
audience).
Turning the light / flexible viewing angle
In order to enable recordings with illumination outside of the working
surface, the light of the Visualizer can be turned vertically.
To record at a lower viewing angle than the normal working position, just
fold the arm of the Visualizer as much as required, turn the camera head
and the light to pick up the desired object.
By default, the unit activates the stanby mode when the arm will be
folded. This behavior can be changed in the unit's on-screen menu (see
page 18).
Image Flip
By turning the camera head to record in front of the Visualizer, the image
will automatically be turned 180 degrees (”image flip”). This feature is
very useful for recording the face of the presenter or objects hanging on
the wall behind the unit.
11
∞