Electrolux EOB3410DAX - Handbuch (Seite 21)

Installing the door and the glass panel
When the cleaning is completed, install
the glass panels and the oven door. Do
the above steps in the opposite se-
quence.
Make sure that you put the glass panels
back in the correct sequence. The second
panel has a decorative frame. The screen-
printing zone must face the inner side of
the door. Make sure that after the installa-
tion the surface of the glass panel frame
on the screen-printing zones is not rough
when you touch it.
Make sure that you install the middle pan-
el of glass in the seats correctly (refer to
the illustration).
10. WHAT TO DO IF…
WARNING!
Refer to "Safety information"
chapter.
Problem Possible cause Remedy
The oven does not heat
up. The appliance is deacti-
vated. Activate the appliance.
The oven does not heat
up. The clock is not set. Set the clock.
The oven does not heat
up. The necessary settings
are not set. Make sure that the set-
tings are correct.
The oven does not heat
up. The fuse in the fuse box
is released. Do a check of the fuse. If
the fuse is released more
than one time, contact a
qualified electrician.
The oven lamp does not
operate. The oven lamp is defec-
tive. Replace the oven lamp.
The display shows 12.00. There was a power cut. Set the clock.
Steam and condensation
settle on the food and in
the oven. You left the dish in the
oven for too long. Do not keep the dishes in
the oven for longer than
15 - 20 minutes after the
cooking ends.
If you cannot find a solution to the prob-
lem yourself, contact your dealer or the
service centre. The necessary data for the service centre
is on the rating plate. The rating plate is
on the front frame of the appliance cavity.
We recommend that you write the data here:
Model (MOD.) .........................................
ENGLISH 21