ROTHENBERGER ROWELD P 125 115V - Handbuch (Seite 17)

ENGLISH 15
3.2.2 Putting out of operation
 Switch off heating element and pull power plug from the socket.
 For safty storage and transportation the machine can be kept in a crate (no. 5.5555).
The hotplate must be cooled off!!
3.3 General requirements
Because weather and environmental influences have a decisive impact on welding, the
corresponding specifications in the DVS guidelines 2207 Part 1, 11 and 15 must be observed
unconditionally. Outside Germany the corresponding national guidelines shall apply.
(The welding work must be monitored constantly and carefully!).
4 Care and maintenance
 Check the heating arbour and jack for signs of damage. If they are damaged they must be
recoated. Material residue is to be removed with non-fibrous paper and methylated spirits.
 The heating element may only be supplied with the voltage specified on the type plate.
 If the mains cable is damaged it must be replaced with a special cable H 05 RR-F.
 Do not use any cleaning products which contain solvents to clean the machine since they
may damage the plastic parts.
It is recommendable to have repairs done only by a service workshop or by the
manufacturer.
5 Accessories
The relevant accessories and an order form can be found from Page 20 onwards.
6 Disposal
Components of the unit are recyclable material and should be put to recycling. For this purpose
registered and certified recycling companies are available. For an environmentalfriendly disposal
of the non-recyclable parts (e.g. electronic waste) please contact your local waste disposal
authority.
For EU countries only:
Do not dispose of electric tools with domestic waste. In accordance with European
Directive 2002/96/EC on waste electrical and electronic equipment and its
implementation as national law, electric tools that are no longer serviceable must be
collected separately and utilised for environmentally compatible recycling.