AEG BE8615001M - Handbuch (Seite 30)

A
2. Hold the inner glass B tightly with
both hands and slide it upwards to
remove it from its initial position. Do
the same with the other glass panels.
Make sure that you tightly hold the
glasses to prevent them from falling.
B
3. Clean the door with a wet sponge
and rub it dry with a soft cloth. Do
not use steel wool, acids or abrasive
cleaning agents because they can
damage the surface.
When the oven door is clean, install the
glass panels in the opposite sequence.
Make sure that you put the glass panels
(A, B and C) back in the correct
sequence. The glass panel (A) has a
decorative frame. Make sure that after
the installation the surface of the glass
panel frame is not rough when you touch
it.
A
B
C
12.7 Replacing the lamp
Put a cloth on the bottom of the interior
of the appliance. It prevents damage to
the lamp glass cover and the cavity.
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp.
The lamp and the lamp glass
cover can be hot.
CAUTION!
Always hold the halogen
lamp with a cloth to prevent
grease residue from burning
on the lamp.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box
or deactivate the circuit breaker.
The back lamp
1. Turn the lamp glass cover
counterclockwise to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Install the glass cover.
13. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
www.aeg.com 30