Lenze GDC GDC getting started - Handbuch (Seite 42)

Global Drive Control
L
40 GDC DE/EN 4.0
3 Software installation
Proceed as follows to install the GDC software on your PC:
1. Start Windows.
2. Insert the CD "Global Drive Control" into your CD−ROM drive.
If the auto−start function of your CD−ROM drive is activated, the installation program will be
started automatically. If so, proceed with step 5.
3. Select Run... from the start menu.
4. Enter the letter for your CD−ROM drive followed by :\setup.exe" (e.g. e:\setup.exe") and
confirm the entry by clicking Ok.
5. Follow the instructions of the installation program.
3.1 Component selection
The installation program enables you to select the components you want to install:
Component Info
Global Drive Control Software for convenient commissioning and parameterization of the Global
Drive Control series 8200 and 9300.
Global Drive Loader Software to transfer PLC programs, parameter sets and application data to
Lenze controllers/PLCs using a PC.
Global Drive Oscilloscope Software for recording and saving measured values in Lenze PLCs.