Retsch AS 450 basic - Handbuch (Seite 14)

Transport, scope of delivery, installation
14
NOTICE
Ambient temperature
– Electronic and mechanical components may be damaged and the
performance data alter to an unknown extent.
• Do not exceed or fall below the permitted temperature range of the
machine (5°C to 40°C / ambient temperature).
Pos : 7.13 /00003 Standard Kapitel/General M odul Luftfeuchtigkeit @ 0\mod_1228918538693_9.doc @ 4738 @ @ 1
Atmospheric humidity:
Maximum relative humidity 80% at temperatures up to 31°C, decreasing linearly up
to 50% relative humidity at 40°C
Pos : 7.14 /00004 Warnhinweis e/H 0011 HIN WEIS Luftfeuc htig keit @ 0\mod_1228918882628_9.doc @ 4788 @ @ 1
NOTICE
Atmospheric humidity
– Electronic and mechanical components may be damaged and the
performance data alter to an unknown extent.
• Do not exceed the admissible range for atmospheric humidity.
Pos : 7.15 /00005 Ü berschriften/1.1 Ü bersc hriften/1.1 Übersc hriften BD A/11 Aufs tell en des Ger ätes @ 0\mod_1226498849756_9.doc @ 3464 @ 2 @ 1
4.5 Installation of the machine
Pos : 7.16 /00010 Bedi enungsanleitung en Kapitels ammlungen/AS450_basic /0006 Transport, Li eferumfang und Aufstellen /AS450 basic M odul Ger ät ausrichten @ 4\mod_1329993637090_9.doc @ 26800 @ @ 1
The device should be erected on a level and stable surface which will not sag and
which is suitable for use during operation.
A level surface ensures the even distribution of the sample across the sieves and
stability of the machine.
Fig. 1: Aligning the device
The flexible feet underneath the machine enables it to be adjusted to the surface.
• Unscrew the lock nut (KM).
• Twist the flexible foot of the device (GF) out or in as necessary.
• Tighten the lock nuts on the feet.
Pos : 7.17 /00003 Standard Kapitel/General M odul Aufstellungshöhe @ 0\mod_1228918538349_9.doc @ 4724 @ @ 1
Installation height: maximum 2000 m above sea level
Pos : 7.18 /00004 Warnhinweis e/H 0058 HIN WEIS Boden Aufstellen Vibr ationen Boden (AS450 basi c) @ 4\mod_1332943698568_9.doc @ 27538 @ @ 1
NOTE
3.H0004
Erection
–
Vibrations can occur depending on the operating status of the device.
• Only erect the device on a level, flat and horizontal surface. The base
must be stable and must not vibrate.
Pos : 7.19 /00005 Ü berschriften/1.1 Ü bersc hriften/1.1 Übersc hriften BD A/11 Spannstange eins etzen @ 4\mod_1330075289191_9.doc @ 26818 @ 2 @ 1
KM
GF