Edit sieve stack file, Main window - description of the menu items – Retsch EasySieve Benutzerhandbuch
Seite 37
Main Window - Description of the Menu Items
37
Interface
: Input of the number of the serial interface (COM no.) through which the
connection was made to the balance. The COM interface must be configured at the
balance in accordance with the works standard for the respective balance (data
bits, baud rate, stop bits, parity).
TimeOut [s]:
Time-out duration during the establishment of communication. If the
Mettler balance is activated, the connection to the balance is checked when the
sieving menu item is called up. The balance must respond within the set time-out
duration. The time must be selected so that the balance will react within this time to
a print command sent from a PC even if the data output is set after standstill.
The length of the signal can be set. If the “fixed length” is selected, the data length
of the signal must be specified. If the “end character” is selected, the ASCII
character must be defined with which the balance communicates the end of the
data signal.
The preset communication parameters for balances from the Mettler and Sartorius
makes: for Mettler and Sartorius balances different modes of communication can
be selected from a list. Please check the operating instructions of your balance to
see if it supports one of the pre-set modes of communication and then select it.
Use the “test” key to test communication with the balance.
Pos: 5.56 /00005 Ü berschriften/1.1.1 Ü berschriften/111 Siebsatzdatei editier en @ 2\mod_1254143025820_9.doc @ 16326 @ 3 @ 1
5.5.3
Edit Sieve Stack File
Pos: 5.57 /00020 BDA Softwar e/20010 EasySieve Kapitelsamml ung/0004 EasySi eve H auptfensters/0420 EasySieve Modul Si ebsatzdatei editi eren @ 2\mod_1254140499850_9.doc @ 16040 @ @ 1
This menu item serves to define sieve stack files. When it is called up, the “Edit
sieve stack file” dialogue box appears.
Fig. 18: Edit Sieve Stack File
Note:
If the sieve stacks are to be used for the next sieving, they must be saved in a file.
This file must then be entered as a sieve stack file into the sieve task and saved.