Weidmuller DFI - 2 channel signal isolator / splitter - Handbuch (Seite 10)

10
Connections
For effective protection from electromagnetic noise, all signal cables
must be shielded, or located on conductive trays or in conduits.
Twisted pair cable should be for the input and output signals.
Use 1-8 AWG Cu Wire rated for temperatures above 70 °C only,
tighten to 4.5 lb-In. Strip wires to 7 mm from the ends. Use a suitable
ferrule for multistranded wires (do not solder).
•Connections
terminal Signal
1 24 V DC (out)
Inputs
2 Current +
3 Common −
4 Voltage +
5 24 V DC (out) - optional
Input channel two
6 Current +
7 Common −
8 Voltage +
9 Neutral (−)
Power supply
10 Live (+)
11 Not used
Outputs 12 Output +
13 Output −
14 Not used
Output channel two 15 Output +
16 Output −
Case Earthing is via a stud on lower side of case