Lupine Betty R 4500 Lumens - 45W - Handbuch (Seite 21)

40 41 Betty R Betty R
Deut
sc
h
Engli
sh
1 W brightness level
0.3W Center-LED **
4 W
brightness level
12 W brightness level
45 W brightness level
22 W brightness level
RVLR*
2 W brightness level
8 W
brightness level
34 W brightness level
16 W brightness level
SOS*
28 W brightness level
Alpine SOS*
Customizing the brightness levels
4
Press and hold the button (for approx. 4 seconds) until one green LED lights up.
 release the button
The range of brightness levels you can select will begin automatically to cycle, as shown below.
Press the button at the brightness level you want.
 the first power-on click is presented
You have the option to setup to 4 brightness levels , in any sequence
4.
3.
2.
1.
Upon releasing the button, the sequence
of brightness levels automatically
restarts , allowing you to set a second
level in the same manner as the first click
set-up. This process can be repeated up
to four times, but will stop when you quit
making further selections, thus allowing
your light to operate in 1-step, 2-step,
3-step,-or 4-step modes.
Default setting
* If in use, shown by green LED
** Will not be signalised by status LED
In special version with XP-E LED 0.8W
Flash*
4
1.
Default setting:
45 W
22 W
2 W 3. brightness level
1. brightness level
2. brightness level
Recover factory settings:
This mode includes an additional slow flash mode.
RVLR:
Press and hold the button until 5 red LEDs turn on.
 release the button
2.
3.
Disconnect the battery, and all factory settings will be restored.
Reconnect the transmitter with the lamphead see page 39.
This mode is extremely irritating and may by no means be misused.
Flash 15hz: (Disorientation)
SOS will continue until the battery is empty. Improper use of the SOS
signal is punishable by law.
SOS:
Alpine SOS will continue until the battery is empty. Improper use of the SOS
signal is punishable by law.
Alpine SOS:
Low beam made by the center LED only.
Center: