Lupine Betty R 4500 Lumens - 45W - Handbuch (Seite 24)

46 47 Betty R Betty R
Deut
sc
h
Engli
sh
Normally the plug contacts are maintenance free. However, if you use your Betty R light in humid,
salt- air, environments, it’s advisable to apply a thin layer of Lupine Dutch Grease to the contacts every
so often to prevent oxidation. Do NOT use terminal grease or contact spray.
Important: Always keep the battery separate from the Betty R light, because otherwise the small
amount of power used by the electronics will discharge the battery, and the lamp may switch on
accidently. Important! Moreover, the consequent uncontrolled heat buildup could cause a fire or
melt the adjacent plastic material. Could cause fire or death !
During lengthy periods of non-use, fully charge the battery and store it in a cool, dry place, basement
or the like. The battery can be kept plugged into the charger if desired.
Open the light housing’s front screw-on cover. Grasp the rear section of the lamp with one hand while
rotating the front section of the cover to the left (counterclockwise) with the other hand. Once you
have removed the cover, you will see the 7-array lens. Do not touch it.
Check to ensure that the O-ring on the rear section of the housing is correctly positioned.
The housing will only be waterproof if its O-ring is intact. After completing this inspection, carefully
screw down the housing cover. Important note: if the thread runs smooth, the cap is in the right
position. Otherwise please stop and screw back the cover and try again, otherwise you might
damage the thread.
Plug contacts:
Transport:
Storage:
Opening the light housing:
Closing the lamp housing:
Product care and storage
7
Receiver:
The housing of the radio receiver on the underside of the lamp head may only
be opened by Lupine.
Troubleshooting
8
Even after charging only
the 20% LED will light up
at the Smartcore battery.
 The indicator was reseted.  Discharge the battery with
your light and fully charge it
afterwards.
 In case the problem still exists.
www.lupine.de/videos/support
For further information how to
recalibrate a battery.
 Extremely discharged battery.
Cause Solution Problem
 Charge the battery.
The light does not come on
and the power LEDs do not
flash when the battery is
plugged into the lamp.
 Faulty LED unit.
With the battery plugged in,
the power LEDs do not come
on, but the PCS LEDs flash.
The Power LEDs do not stay on for
as long as they should.
 Discharged battery.
 Old battery.
 Very low ambient
temperature.
 Faulty charger.
 Unsuitable battery.
 Replace the LED unit.
 Charge battery.
 Replace battery.
 Keep battery warm.
 Replace charger.
 Use original Lupine battery.
The lamp does not recognize
the transmitter.
 Lamphead and transmitter are
not linked.
 See chapter operation
remote control.
The transmitter does not light up
while pressing the button and the
lamp does not react.
 Button cell empty or wrong
side up.
 See chapter operation
remote control.
 Check all plug contacts.  Battery not plugged into the
light or not plugged in properly.