Lupine Betty TL2 /s - Handbuch (Seite 14)

26 27 Betty TL2 Betty TL2
Deut
sc
h
Engli
sh
4 4
Customizing the brightness levels
In stealth mode, initialization, voltage display, and battery warning usually indicated by
the button's LEDs are partly deactivated. Of course “stealth on“ does not mean that our
Betty TL will no longer give light or will even become invisible, however, LED indications
will be reduced to a minimum.
This mode is extremely irritating and may by no means be misused.
This setting activates the center LED to produce a
low red light. The outer 6 LEDs will be disabled.
If this function is activated, the lamp may only be switched on with a quick double
click. Useful for anybody who wants to avoid that the lamp is switched on acciden-
tally in particular during transport (e. g. in a backpack).
The SOS sign is an emergency signal! Use it carefully
and only in case of a real emergency. Due to the lamp's
high light output, this signal is visible for several miles;
the operating time is several hours.
Misuse may be prosecuted!
Stealth:
Center
Double click:
Flash:
SOS:
Press and hold the button until one green LED lights up.
 release the button
The range of brightness levels you can select will begin automatically to cycle, as shown below.
Press the button at the brightness level you want.
 the first power-on click is presented
You have the option to setup up to 4 brightness levels, in any sequence.
0.3 W brightness lvl
dbl click
3 W
brightness lvl
12 W brightness lvl
45 W brightness lvl
22 W brightness lvl
SOS**
2 W
brightness lvl
8 W brightness lvl
34 W brightness lvl
16 W brightness lvl
center (0.8W)*
28 W brightness lvl
flash**
Default setting
Upon releasing the button, the sequence of
brightness levels automatically restarts , al-
lowing you to set a second level in the same
manner as the first click set-up. This process
can be repeated up to four times, but will
stop when you quit making further selec-
tions, thus allowing your light to operate in
1-step, 2-step, 3-step,-or 4-step modes.
4.
3.
2.
1.
* If in use, shown by green LED
** Will not be signalised by a status LED
stealth