ALTANA Temp-Gard Basic - Handbuch (Seite 36)

temp-gard basic Hardware
15
• Remove the hot thermal barrier from the belt wearing appropriate protective clothing
(protective gloves). Open the thermal barrier and press the start/stop key of the data
logger.
• Take out the SRAM- card .
Cooling Down the Protective Parts
• Place hot thermal barriers on heat-resistant spacers, a ceramic fiber blanket or
refractory material to ensure uniform cooling. Placing a hot thermal barrier directly
onto a cold surface may cause the housing to deform due to the different cooling rates
of the surfaces.
• Do not remove the cover before the thermal barrier is in place
• Since the heat absorbed by the thermal barrier continues to affect the temperature of
the heat sink (optional) and data logger, remove these parts from the thermal barrier
as soon as the test is completed. Allow them to cool down before further use. In most
cases cooling overnight is sufficient.
• Please observe the safety information on page 3.
How to print a protocol
• Connect
the inerface to a Canon printer.
•
Connect the power cord of the printer to the mains supply.
• Switch on the printer by pressing the POWER key.
• The
printer will initialise for normal operation. Do not starting before the initialising
process is completed.
•
Put the SRAM-card containing the measurement data into the drive of the printer
interface.
• The
printer will automatically start printing the chart and data values on a size A4
sheet in the language selected,
• By
removing and re-inserting the SRAM-card, the printer will start printing again.
•
The SRAM-card can then be used for further meassurements.
Reformatting the SRAM-card
•
Introduce the SRAM-card into the drive of the temp-gard basic instrument
• Switch on temp-gard basic with the the start/stop key.
• By
simultaneously pressing the mode and operate keys the formatting program is
activaded.
• Confirm the formatting with the operate key .
•
When the formatting process is completed after a few minutes a standard
measurement can be taken.
Changing the Contrast in the Display
•
Introduce the SRAM-card into the drive of the temp-gard basic instrument.
• Switch on the instrument with the start/stop key.
•
Press the start/stop and mode keys simultaneously.
•
Change the contrast with help of the operate or mode key.