Philips AW 7091 - Handbuch (Seite 4)

To improve SW-reception, vary the length of the
aerial.
• When the BAND selector 0 is in position FM
STEREO and the FM STEREO indicator 0 lights up,
you are receiving a FM-stereo transmitter. A disturb­
ing noise, due to a weak FM-stereo signal, can be
suppressed by setting the BAND selector 0 to FM
MONO. The FM STEREO indicator© will then go out
and you will hear (and record) the FM programme in
mono.
• The set is switched off if ON/OFF-MODE selector
0 Is in position RADIO OFF ¡7] [7] or |T] and the
recorder buttons are released.
CASSETTE RECORDER
Compact cassettes
For recording, use only NORMAL cassettes (feme
oxide, lEC type I).
For playback, any cassette type can be inserted.
Copyright
Recording is permissible insofar as copyright or
other rights of third parties are not infringed.
For U.K onJy; Recording and Playback of material may require
consent See Copyright Act 1956 and The Performer’s Protection Acts
1958 to 1972.
Fast winding and rewinding
Press fast forward wind F.FWD ^ or REWIND ^
button. To stop fast winding, press STOP button ■.
Safeguarding a cassette against erasure
Keep the cassette side to be safeguarded in front of
you (fig. 4) and break out the left tab. Now, recording
on this side is no longer possible.
You can render this safeguard ineffective by covering
the aperture with a piece of adhesive tape.
RECORDING (on deck B only)
Recording from the radio
• Set the ON/OFF-MODE selector © to Q] RADIO
ON.
• In case of FM radio recordings, set the BAND
selector©to the desired position (FM MONO or FM
STEREO).
Mono recording from the microphone MIC ©
• Set the ON/OFF-MODE selector ©to [7] MICRO­
PHONE.
• Set the VOLUME control © to zero (during
microphone recordings, monitoring is not possible).
Starting and stopping
• Start recording by pressing RECORD •; in doing
so. PLAY i is pressed too.
• For brief interruptions, press PAUSE II . To restart
recording, press this button once more.
• To stop recording, press STOP ■. On pressing
again, the cassette holder vinll open.
• The set is switched off if ON/OFF-MODE selector
© is in position RADIO OFF [7] [7] or 0 and the
recorder buttons are released.
DUBBING - Copying from deck A to B
• Set ON/OFF-MODE selector © to;
S HIGH SPEED DUBBING for high speed copying;
NORMAL SPEED DUBBING for normal speed
copying.
Do not switch this selector during dubbing.
• Press both EJECT buttons ■ and insert a record­
ed cassette into deck A and a cassette which is
suited for recording into deck B (fig. 3).
• Dubbing wiil start by pressing at the same time on
deck A PLAY i and on deck B RECORD •.
• By pressing PAUSE II on deck B. you can omit
undesired passages while deck A continues, or you
can insert another cassette in deck A and search for
a particular passage on it. To restart copying, press
PAUSE
II once more.
• Using PAUSE II of deck A. deck B will record a
blank part.
• To stop dubbing, press both STOP buttons ■.The
set is then switched off.
Preparation
- During recording, the deck A buttons should not be
pressed (except for PLAY i during dubbing).
-When copying, it is recommended to use fresh
batteries or to connect the set to the mains.
• Press EJECT ■ to open the cassette holder.
• Insert the cassette into deck B (fig. 3).
For recording you must use a NORMAL cassette (lEC
type I) on which the tabs (fig. 4) are not broken out.
At the very beginning of the tape, no recording wiil
take place duringthe first Tsecondswhentheleader
tape passes the recorder heads.
•
When monitoring during recording, adjust the
sound with the VOLUME controi ©.This controi does
not affect the recording.
CASSETTE PLAYBACK •
Playback on deck A or B
During playback, the tape in the other deck should
not be fast forward v/ound or rewound, otherwise the
actual cassette playback is affected.
• Set ON/OFF-MODE selector ©to TAPE (0 or [7]).
•
Press EJECT ■ and insert a recorded cassette
(fig.3).
• Adjust the sound with the VOLUME controi ®.
You may connect stereo headphones with 3.5 mm
plug to socket ¡¡7, ©. The loudspeakers are then
muted.
• Press PLAY i and playback will start.
• To stop playback, press STOP ■. The set is then
switched off.