AUDIOLINE BabySense5-Video - Handbuch (Seite 40)

Connecting the receiver
a
Attention: Position the receiver with a minimum distance of 1 m to other electronic devices,
otherwise there is a risk of mutual disturbance.
Operating with a power adapter plug
Connect the receiver as illustrated in the diagram. For safety reasons, only use the power adapter
plug supplied.
Operation with rechargeable batteries
1. Open the battery compartment on the rear side of the receiver.
2. Insert the battery pack, and connect it with the socket. The connector can only be fitted one way.
3. Close the battery compartment again.
The receiver is powered by a a Lithium-ion battery pack of 3.7 V, 1500 mAh.
The rechargeable battery pack can be recharged directly in the receiver when it is inserted in the
charging station. The Power LED lights up when the receiver is being charged.
In the case of a low battery charge, the Power LED flashes slowly. The battery pack must then be
recharged.
Mounting/dismounting the belt clip
Prize the latch (see figure) with a suitable tool (such as a small screwdriver) a litt-
le bit away from the chassis and move the belt clip down simultaneously. To
attach the belt clip slide it into the guide towards the top until it snaps in.
Optimization of range
Baby unit and parent unit come with fold-out antennas. If
necessary, optimum range can be achieved if both the
Baby unit and Parent unit antennas are extended verti-
cally.
LINK
Mains power outlet
Starting Up
4