AXING TAA 3-00 - Handbuch (Seite 3)

State of the art 2015-04-28 - Reserving change in design and type -
We cannot be held liable for printing errors Manufacturer
AXING AG
Gewerbehaus Moskau
CH-8262 Ramsen EWR contact adress
Bechler GmbH
Am Rebberg 44
D-78239 Rielasingen
Safety advice:
4 Installation and repairs to the equipment may only be carried out by
technicians observing the current VDE guidelines. No liability will be
assumed in the case of faulty installation and commissioning.
4 Before opening the equipment pull out the power plug or remove the
power supply, otherwise there is danger of electrocution. This is also
valid for cleaning the equipment or working on the connections.
4 Providing that a serviceable fuse exists, the power cord must be pulled
out before changing the fuse. Defective fuses may only be replaced with
standard compliant fuses that have the same nominal value.
4 Choose the location of installation or mounting so that the power plug
can be reached and pulled out of the socket easily in case of danger.
Choose the location of installation or mounting such that children may
not play unsupervised near the equipment and its connections. The
location of installation or mounting must allow a safe installation of all
cables connected. Power feeding cables as well as feeder lines may not
be damaged or clamped by objects of any kind. To prevent damage to
your equipment and to avoid possible peripheral damages, the devices
foreseen for wall mounting may only be installed on a flat surface.
4 Use only the plug-in power supply unit included in the delivery scope!
By no means is it allowed to replace any parts of the power supply unit
or to make modifications. Otherwise, there is a risk of mortal injury for
which we cannot be held liable.
4 Choose the location of installation or mounting of the plug-in power
supply so that under no circumstances liquids or objects can get into the
power supply (e.g. condensation, water coming from leaking roofs or
flowing water, etc.).
4 Avoid exposure of the power supply to direct sunlight and to other heat
sources (e. g. radiators. other electrical devices, chimney, etc.). Power
supplies that are equipped with heat sinks or ventilation slots must
under no circum-stances be covered or blocked. Also ensure for a
generous air circulation around the power supply. In this way you avoid
possible damage to the power supply as well as a risk of fire caused by
overheating. Absolutely avoid that cables come near any source of heat
(e.g. radioators, other electrical devices, chimney, etc.).
WEEE Nr.
DE14023300
Your device is marked with the WEEE symbol (Waste Electronics
and Electrical Equipment). This means that the electrical and
electronic components must not be disposed of as residual waste.
Used electrical and electronic components must be disposed of
separately.
Technical specifications:
Frequency range ...........................................................................85…862 MHz
Gain ............................................................................28 dB (VHF), 27 dB (UHF)
3rd order output level ......................................................100 dµV (EN 50083-3)
Noise figure...............................................................................................< 4dB
remote feeding via receiver .................................................................5…12 V=
Current consumption ................................................................................80 mA
plug-in power supply unit......................................230 V~ 50 Hz | 6V= /500 mA
TAA 3-00
DVB-T | UKW | DAB+
antenna
Operation Instructions