H3C Technologies H3C S5800 Series Switches - Handbuch (Seite 10)

6
Denmark
• The supply plug must comply with section 107-2-D1, standard DK2-1a or
DK2-5a.
Switzerland
• The supply plug must comply with SEV/ASE 1011
• Der Netzstecker muss SEV/ASE 1011 entsprechen.
Argentina
(for 3 pins)
• El conjunto de cables debe estar certificado por UL, IRAM, TÜV (u otra
organización de certificación autorizada), para cables de tres
conductors.
• El enchufe de conexión debe ser de tipo de toma de tierra con una
configuración IRAM-2073 (10 A, 250 V).
• The power cord set must be certified by UL, IRAM, TÜV (or other
authorized certification body), for three conductors cables.
• The attachment plug must be an earth-grounding type with an
IRAM-2073 (10 A, 250 V).
中国
•
电源线组件必须通过 CCC 认证。
•
使用符合 GB1002，额定值为 250V/10A 的单相两级带接地插头
•
电源线最小线径为 1.0mm 2
The appliance coupler (the connector to the unit and not the connector to the wall plug) must have a
configuration for mating with an EN 60320 / IEC 320 C13 appliance inlet.
Die Gerätesteckvorrichtung (der Anschluss an die Anlage, nicht an den Wandstecker) muss mit einer
Konfiguration nach EN 60320 / IEC 320 C13 versehen.
For the equipment with Power Supply HPSR300-A, the power cord set must be approved for the country
where it is used:
Für die Ausstattung mit Netzteil HPSR300-A, das Netzkabel muss für das Land, in dem es verwendet
wird, zugelassen werden:
如果设备使用 HPSR300-A 电源，电源线的使用必须满足下面国家列表的要求：
Warning Power Cord Table:
The power cord set must be approved for the country where it is used.
WARNUNG Netzkabel Tabelle:
Das Netzkabel muss für das Land, in dem es verwendet wird, zugelassen werden.
警告：电源线表格：
电源线组件必须满足使用的国家认证要求。
U.S.A. and
Canada
• The cord set must be UL approved and CSA certified
• The minimum specification for the flexible cord is:
• No. 18 AWG
• Type SV / SVT or SJ / SJT or SPT-2
• 3 conductor.
• The cord set must have a rated current carrying capacity of at least 10A.
• The attachment plug must be an earth-grounding type with a NEMA
5-15P (15A, 125V) or NEMA 6-15P (15A, 250V) configuration
United Kingdom
• The supply plug must comply with BS1363 (3-pin, 13A) and be fitted with
a 13A fuse that complies with BS1362
• The mains cord must <HAR> or <BASEC> marked and be of type
H03VVF3G1.0 (minimum).
Europe • The supply plug must comply with CEE 7/7 (“SCHUKO”)