Crivit Z31425 - Handbuch (Seite 4)

4 GB/IE
Kids’ Paddling Pool
Intended use
This article is intended for use for playing / paddling.
This product is intended for private, outdoor use
only. The product is not intended for commercial use.
Technical data
Dimensions: 150 (ø) x 32 cm (when inflated)
Weight: approx. 1600 g
Contents
1 paddling pool
2 repair patches
1 instruction manual
Safety advise
Avoid the risk of injury!
RISK OF
LOSS OF LIFE OR ACCIDENT
TO INFANTS AND CHILDREN!
Never leave children unsupervised with the
packaging material or the product. The packaging
material presents a suffocation hazard and there
is a risk of loss of life from strangulation and / or
drowning. Children often underestimate danger.
Children can drown in very small amounts of
water. Empty the pool when not in use.
Do not install the paddling pool over concrete,
asphalt or any other hard surface.
When filling with water, the maximum depth of
the water should not exceed children‘s shoulders
in sitting position.
Once inflated, make sure that the product does
not come in contact with stones, gravel or other
sharp objects which could puncture the item.
Operation
Note: Before using the product for the first time,
check it carefully for holes, porous places and seams
that are not airtight.
Recommendation: Pump the product up and
leave it alone for one day. Let a new product air
outside in fresh air for a couple of days.
Pumping up the product
CAUTION! Inflatable plastic products react sensi-
tively to the cold and hot. That is why you should
never use the product when the ambient temperature
falls to below 15 ° C and rises above 40 ° C.
Otherwise damage to the product may result.
Note: Basically, only an adult should be responsible
for pumping the product up. Make sure that you do
not pump too much air into the product. On no account
should you use a compressor. Stop the process when
resistance increases during pumping and the seams
start to stretch. Otherwise the material might tear.
Only use manual pumps and / or pumps specifically
designed for use with inflatable plastic products.

Roll the product out first and then check for
holes, tears, and other damage.
 Open the air valve (see Fig. B I).

Press the air valve together and blow or pump
the product up until it is tautly stretched.
CAUTION! On no account should you use
compressed air. Otherwise the product could
burst or the seams could tear.

Close the air valve (see Fig. B II).
 Push the air valve in (see Fig. B III).
IMPORTANT! Keep in mind that air temperature
and weather conditions can affect the air pres-
sure inside inflatable products. In cold weather