Crivit Paddling Pool - Handbuch (Seite 4)

5
Disposal
Please dispose of the product and packaging in
an environmentally friendly manner, separating
different materials for recycling as required! Dis-
pose of this item through an authorised disposal
company or through your local waste disposal
facilities - ask your local authority for information
if further guidance is required. Ensure that you
comply with all regulations currently in force.
3-year warranty
The product was produced with great care and
under constant supervision. You receive a three-
year warranty for this product from the date of
purchase. Please retain your receipt.
The warranty applies only to material and
workmanship and does not apply to misuse or
improper handling. Your statutory rights, espe-
cially the warranty rights, are not affected by this
warranty.
With regard to complaints, please contact the
following service hotline or contact us by e-mail.
Our service employees will advise as to the
subsequent procedure as quickly as possible.
We will be personally available to discuss the
situation with you.
Any repairs under the warranty, statutory gua-
rantees or through goodwill do not extend the
warranty period. This also applies to replaced
and repaired parts.
Repairs after the warranty are subject to a
charge.
IAN: 71325
Service Great Britain
Tel.: 0871 5000 720 (£ 0.10/Min.)
E-Mail: [email protected]
Service Ireland
Tel.: 1890 930 034
(0,08 EUR/Min., (peak))
(0,06 EUR/Min., (off peak))
E-Mail: [email protected]
GB/IE
• Do not use a compressor or a compressed
air bottle to inflate the article as this can cause
damage.
• Make sure that all of the chambers are infla-
ted to the same pressure, one after the other.
• Pump the chambers up so that they feel tight
to the touch. You should be able to press the
surface in slightly, using your thumb.
Assembling the Screw Valves
(Fig. B )
The air chambers are each equipped with a
screw thread for screwing in the enclosed valves.
Pull the valve loop over the screw thread
as shown, so that it sits firmly in its intended
groove. This process requires a little patience
and must be done carefully so that the valves
do not loosen. Now turn the base clockwise
firmly into the screw thread. Inflate the cham-
bers with air and close the cap (Fig. B) in a
clockwise direction.
Emptying the Water (Fig. C )
Open the water outlet valve at the base of the
article.
Deflating (Fig. B )
To deflate the air chambers, completely unscrew
and remove the screw valve from its base.
Care, Storage
Change the water in the pool on a regular basis,
especially during warm weather and when it
gets dirty! Always store the article uninflated in
a dry, clean and cool room. During storage, the
valves should always be closed. Clean only with
water or soapy water and never with aggressive
cleaners or solvents.