Florabest FHE 710 A1 - Handbuch (Seite 15)

15
GB IE CY
3. Turn blade fixing screw (4) clockwise
to retighten blade (2).
Where saw chain (1) has been newly
tensioned, readjust the chain tension
after a short period in operation.
Check the chain tension before
each use of the electric pruner.
Chain lubrication
Always switch off the device
and allow the motor to cool
before filling with chain oil.
There is a risk of fire if chain
oil overflows.
Blade ( 2) and saw chain ( 1)
must always be oiled. Non-obser-
vance of this will result in increased
wear on the blade and saw chain.
A full tank will last for approx.
10 minutes of continuous operation.
Check the oil level in good time.
The electric pruner is equipped with an oil
automatic system. As soon as the motor is
speeded up, the oil also flows faster to the
chain bar ( 2). Before starting work,
check the oil level in the oil automation sys-
tem (see “Operation startup”).
Filling up with chain oil:
• Check the oil fill level in the oil level
inspection window (27) and regularly
top up with chain oil.
• Use Grizzly bio-oil; this product con-
tains additives that reduce wear and
tear and does not damage the pump
system. bio-oil is available from our
Service-Center (see P. 23 for the ad-
dress).
• If you have no Grizzly bio-oil availa-
ble, use chain lubrication oil with low
adhesive additive content.
1. Unscrew the oil fill cap (28) and fill up
with chain oil.
2. Wipe off any spilled chain oil and
close the cap again.
Note that the saw can re-oil.
Operation startup
Observe the country-specific and
municipal regulations.
Do not work with the electric pruner
during general ordinary or pre-
scribed quiet periods.
Before starting, check
• Check the tension of saw chain
( 1).
• Check the chain oil level.
• Check all nuts and screws are sitting
firmly.
• Only remove blade cover ( 18) at
the last minute.
• Set the working length of the telescopic
arm before switching on the equip-
ment.
• Check the shoulder belt ( 14) for
comfortable positioning which facili-
tates holding the device.
• Ensure that you are wearing protective
clothing.
• Check that you are standing safely.
• Check your working surroundings.