Florabest FLB 3000 A1 - Handbuch (Seite 35)

34
GB
vide you with better results and increased safety.
Follow the instructions for lubrication and for re-
placing accessory parts.
Check the mains cable for the tool regularly. If it
should be damaged then have this replaced by
an approved customer support centre.
Check the extension cable regularly and replace
it if it is damaged.
Keep grips dry, clean and free of oil and grease.
Take care to ensure that the ventilation slots are al-
ways clear and free of dust. Blocked ventilation slots
can lead to overheating and can damage the motor.
Disconnect the power tool from the mains
Ensure that the power tool is disconnected from
the mains when not in use, before it is serviced
or lubricated, before adjustments are carried out
on it, or when accessory parts such as blades,
drill bits and cutters are replaced.
Removal of adjustment wrenches
Make it a consistent practice to always check that
there are no adjustment wrenches remaining on
the power tool before you switch it on.
Avoidance of unintended switching on
Ensure that the switch is in the OFF position be-
fore you connect the power tool to the mains.
Extension cables and cable drums
The device should be operated via a residual cur-
rent circuit breaker (RCD) with a triggering current
of max. 30 mA.
DO NOT USE cable drums or extension cables
with a two-core cable to operate a power tool
with an earth wire. Always use an extension ca-
ble or cable drum with a three-core cable whose
earth wire is connected.
If the power tool is to be used outdoors, use only
extension cables that are intended for outdoor
use and which are labelled as such.
Always unroll extension cables completely.
Extension cables must have a conductor cross
section of at least 1.5 mm
2 .
Damaged extension cables must not be used but
rather must be replaced.
Protect your extension cable from sharp edged
objects or from excessive heat and moisture or
wet locations.
Stay alert
Proceed cautiously, use your common sense and
do not operate the power tool if you are tired, if
you are taking medication that makes you drowsy
or if you have consumed alcohol or drugs.
Checking of damaged parts
The power tool should be carefully checked be-
fore use to ensure that it is working properly and
fulfilling its intended purpose.
Check that the moving parts are correctly aligned
and ensure that they are able to move freely.
Check the tools for damaged or missing parts
and if necessary have these replaced or repaired
at an authorised customer support centre. If the
power tool has to be mounted then ensure that it
is safely secured on a suitable workbench. Check
all other conditions that could have an influence
on the operation of the power tool.
If protective coverings or other parts of the power
tool are damaged then these should be replaced
or repaired in an authorised customer support
centre insofar as these operating instructions do
not specify otherwise.
Any switch that does not work flawlessly must be
replaced by an authorised customer support centre.
Do not use the power tool if the On-Off switch
of the power tool does not switch on and off se-
curely and reliably.
Warning ! Do not carry out any alterations
to the power tool. The use of attachments or
accessories other than those recommended
in these operating instructions could dam-
age the power tool and could present a risk
of injury for the operator. Have your power
tool repaired by a qualified person.
This power tool fulfils the national and interna-
tional standards and safety requirements. Repairs
should only be carried out by qualified persons
using original replacement parts. Otherwise there
may be considerable hazards for the user.
Special safety instrucions leaf blowers/
vacuums
Warning against use by children!
Never let children or persons who have not read
and understood these operating instructions use
the leaf blower/vacuum. Do not use the leaf
blower/vacuum for purposes other than those
described in these operating instructions.
Read the warning labels on the machine and re-
place any damaged or illegible warning labels.
Read through these operating instructions care-