Playtive Aluminium Scooter - Handbuch (Seite 6)

6 GB/CY
3 years warranty
The product was produced with great care and
under constant supervision. You receive a three-
year warranty for this product from the date of
purchase. Please retain your receipt.
The warranty applies only to material and
workmanship and does not apply to misuse or
improper handling. Your statutory rights, espe-
cially the warranty rights, are not affected by this
warranty.
With regard to complaints, please contact the
following service hotline or contact us by e-mail.
Our service employees will advise as to the
subsequent procedure as quickly as possible.
We will be personally available to discuss the
situation with you.
Any repairs under the warranty, statutory gua-
rantees or through goodwill do not extend the
warranty period. This also applies to replaced
and repaired parts. Repairs after the warranty
are subject to a charge.
IAN: 103908
Service Great Britain
Tel.: 0871 5000 720
(£ 0.10/Min.)
E-mail: [email protected]
Service Cyprus
Tel.: 8009 4409
E-mail: [email protected]
You can also find spare parts for your product at:
www.delta-sport.com, category Service - Lidl Spare
Parts Service
After replacing:
Do not use if the wheel grinds on the
sides following replacement!
Make sure that all screws are still se-
cure and have not loosened after the
first few minutes of riding.
Tighten the wheel again to make sure
that it runs smoothly and that no noises
are coming from the bearings.
Exchanging the ball bearings
(Fig. j)
• Remove wheels (17) as described with an
Allen key and (page 5 - 6).
• Remove one bearing by pressing on the
spacer (18) with a setscrew wrench and
remove the spacer.
• Remove the other bearing (19), pushing it
out with an Allen key.
• Insert a new bearing. Flip the wheel, insert
the spacer, and then push in a second new
bearing.
• Reattach the wheels.
Care, Storage
It is recommended that the product be tho-
roughly cleaned and dried after being used.
Remove small stones or other objects that may
have remained on your wheels. Dry off wet or
damp ball bearings with a clean cloth.
Oil the bearings from the outside with a suita-
ble bearing oil to prevent rusting. Always store
the product in a dry place.
Disposal Information
Dispose of the product and all corresponding
components through an approved waste dispo-
sal company or through your municipal waste
disposal provider. Please observe the currently
valid regulations. In case of doubt, ask your
waste disposal provider about environmentally
sound disposal.