Ultimate Speed ULGD 3.8 A1 - Handbuch (Seite 9)

9 GB/IE/CY
Operation / Maintenance and care Operation
is fully charged, the condition display 8 shows
4 bars. The flashing stops and the appliance
automatically switches to retention charge.
Programme 2 „12 V“
(14.4 V / 0.8 A)
For charging 12 V batteries with a capacity of less
than 14 Ah.
Press the programme selection button 10 , to
select programme 2. The symbol is dis-
played on the LCD. During charging, the charge
display
7 flashes and shows the progress of
the charge procedure (1–4 bars). When the
battery is fully charged, the condition display
8
shows 4 bars. The flashing stops and the appli-
ance automatically switches to retention charge.
Programme 3 „12 V“
(14.4 V / 3.8 A)
For charging 12 V batteries with a capacity of be-
tween 14 Ah–120 Ah.
Press the programme selection button 10 , to se-
lect programme 3. The symbol is displayed
on the LCD. During charging, the charge dis-
play
7 flashes and shows the progress of the
charge procedure (1–4 bars). When the battery
is fully charged, the condition display
8 shows
4 bars. The flashing stops and the appliance
automatically switches to retention charge.
Programme 4 „12 V“
(14.7 V / 3.8 A)
For charging 12 V batteries with a capacity of be-
tween 14 Ah–120 Ah under cold conditions or for
charging AGM batteries.
Press the programme selection button 10 , to
select programme 4.
NOTE: This programme may start with a minute
delay. The symbol is displayed on the LCD.
During charging, the charge display
7 flashes
and shows the progress of the charge procedure
(1–4 bars). When the battery is fully charged,
the condition display
8 shows 4 bars. The
flashing stops and the appliance automatically
switches to retention charge.
Retention charge
As described under programmes, this appliance
features the automatic retention charge. Depending
on the voltage drop of the battery, caused by self-
discharge, the appliance reacts with different charge
currents.
The battery can remain connected to the charger
for longer periods of time.
Appliance protection function
The charger switches the electronics off and switches
the system instantly to the basic setting, as soon as
there is an abnormal situation, such as short circuit,
critical voltage drop during charging, broken circuit
or swapped connection of the connector clamps is
detected.
Should the appliance become too hot during charg-
ing, the output current is automatically reduced.
This protects the appliance from damage.
Maintenance and care
Before you carry out any work
on the battery charger always pull the mains
plug out of the mains socket.
The appliance is maintenance-free.
Do not under any circum-stances use solvents
or other aggressive cleaning agents.
Clean the plastic surfaces of the device with
a dry cloth.