Seagate BARRACUDA 4 FAMILY ST15150W/WD/WC - Handbuch (Seite 33)

Barracuda 4 Installation Guide, Rev. E 31
2. Verify that all connections between the drive and the
host system are correctly installed.
2. Prüfen Sie, ob alle Verbindungen zwischen dem
Laufwerk und dem Host-System korrekt hergestellt
sind.
3. Verify that you have correctly installed SCSI ID jump-
ers (see Figure 10, 15 or 21).
3. Stellen Sie sicher, daß die SCSI-Kennungsbrncken.
Siehe Abbildung 10, 15 und Abbildung 21.
4. Connect the 50-pin SCSI cable into the drive’s SCSI
connector (shown earlier in Figures 1, 2 and 3). Take
care not to stretch or crimp this cable, and do not
block the system’s cooling air flow with the cable.
The drive receives DC power through a 4-pin con-
nector mounted next to the SCSI connector. The
output of a power supply must meet SELV (safety
extra low voltage) as defined in IEC 950. Figure 9
provides the pin information for the DC power con-
nector. To connect the DC power cable to the drive,
simply insert the cable end into the drive’s DC power
connector.
4. Schließen Sie das 50-polige SCSI-Kabel an den
SCSI-Steckverbinder des Laufwerkes an (wie bereits
in Abbildung 1, 2 und Abbildung 3 gezeigt). Das Kabel