Revox M642 HD - Handbuch (Seite 37)

Getting started
9 ENGLISH
Table installation Wall mounting
30 cm Space
10 cm
Space
80
cm
S
p
ac
e
10
cm
S
p
ac
e
80 cm Space
10 cm Space
10 cm
Space 10 cm
Space
Installation
D Two persons are required to remove the plasma display from the packing. Never lift the display alone.
Any attempt to lift the display alone will pose a risk to your health.
D Place the display on a stable, horizontal base. The base must be solid and capable of bearing the load.
D Before installing it, make sure that the display is switched off and that the mains cable and signal cable
are unplugged.
Wall mounting
D The plasma display screen may be mounted on vertical walls only.
D Before mounting it check whether the loadbearing capacity of the wall is suitable for 3-times the weight
of the plasma display screen (for the weight see page 25 ”Technical Specifications”). If in doubt, seek
the advice of a qualified installer.
D Before installing it, make sure that the display is switched off and that the mains cable and signal cable
are unplugged.
D Two people are required to mount the display screen on the wall.
. Turn the plasma display screen so that the front side
(screen) is pointing downwards and place it on a comple-
tely flat and firm surface.
. A Revox table foot is optional available.
. Fit the 2 fastening hooks (rawl plugs and fastening hooks
are not included in the items supplied) horizontally and with
the appropriate distance between them (for this distance
see drilling template in the accessories pack) to the wall.
The fastening material must be designed for 3-ti-
mes the weight of the plasma display screen. If
necessary, please consult a qualified installer.
. Position the plasma display screen so that the fastening
hooks can be introduced into the openings provided for this
purpose on the rear side of the appliance.
E
N
GL
IS
H
Holes for
rackets
Screws from
the table foot
Optional: Revox table foot