Revox M642 HD - Handbuch (Seite 38)

Getting started
10 ENGLISH
Connecting and switching on the display
Connecting the display
(for an overview of the connection sockets see the illustration on page 6 )
. Plug the mains power cord into the mains input jack on the plasma TV and
the mains plug into a plug receptacle.
Cable connection / terrestrial aerial
If you would like to connect a cable, a terrestrial aerial or a satellite recei-
ver, use the ANTENNA socket for this purpose.
Video recorder / DVD player / satellite receiver
If you receive your TV channels via satellite, connect your receiver by
means of a SCART cable to the SCART 1 or SCART 2 socket.
In addition, SCART 1 has a connection socket for RGB sources,
e.g. a DVD player.
Only a SCART 2 can be used for connecting a decoder.
DVD player
For connection of a DVD player or another video source to a YUV-output
please use the display’s YUV-input.
If your DVD player has a DVI-I output port, you can use the DVI-I input
port and the audio input port LINE IN PC on the display screen.
f a DVD player is connected to the DVI-I input port of the dis-
play screen, the following must be ensured:
D Before you make a connection between the DVD player and
the display screen using the cables, you must disconnect
the mains plug of the DVD player from the plug socket.
D Once the cables are plugged in on the DVD player and on
the display screen, the mains plug of the DVD player can be
reconnected to the mains.
If you do not comply with this procedure, damage can be
caused to the DVD player or to the display screen!
Notice : If your DVD player has a HDMI interface, you use to the connec-
tion the supplied adapter cable ”HDMI on DVI”.
PC
Use the PC DVI-I socket to connect your PC to the display. If your PC has an
analogue VGA output port, use the DVI-I connecting cable supplied on a 15
Pin HD-Sub to connect it.
On older PC graphic cards it is possible that pin 9 is barred.
Should this be the case, please contact the service hotline.