Yamaha CLP-860 - Handbuch (Seite 49)

49 CLP-880/860/840/820/820S
2 3
B
B
D
B
B
● If applicable, align the
cut corner of the bracket
with the corresponding
cutouts on the feet.
5 x 40 mm long gold screws 1
6 x 20 mm round-head screws
2
◆ It is not necessary to perform this procedure on the CLP-880PE.
X
Assemble the side panels (B) and feet (C).
Secure the feet (C) to the side panels (B) with the 5 x 40
millimeter long gold-colored screws 1 (3 each).
Depending on the unit type, the feet (C) may or may not have
cutouts. If the feet have cutouts, make sure that the cutouts on the
feet face the bracket side of the side panels.
◆ It is not necessary to perform this procedure on the CLP-880PE.
C Attach the side panels (B) to the pedal box
(D).
Before installing the pedal box, untie and straighten out the
bundled cord attached to the bottom of the pedal box.
Place the pedal box on top of the brackets attached to the side
panels (B), and attach using the four 6 x 20 millimeter round-head
screws 2 — two screws on each side. Make sure the pedals extend
in the same direction as the feet.