Zanussi ZOU 461 - Handbuch (Seite 26)

26
Electronic programmer
4
5
1 2 3
6
7
8
1. Push button for selecting a function
2. Decreasing control button “ ”
3. Increasing control button “ ”
4. Display
5. “Cooking Duration” pilot lamp
6. “End of cooking” pilot lamp
7. “Minute minder” pilot lamp
8. “Time of day” pilot lamp
The oven will only work if the time of day
has been set.
However, the oven can also be operated without
any programme.
In the event of a power failure, all the settings (time
of day, programme setting or programme in
operation) will be cancelled. When the power is
restored, the numbers in the display will flash, and
the clock/timer has to be reset.
Setting the time of day
When the power supply is switched on, or after a
power failure, the “Time of day” pilot lamp will flash on
the display.
To set the correct time of day:
1. Press button “ ” or “ ”.
2. After the setting is carried out, wait for 5 seconds: the
“Time of day” pilot lamp will go out and the display
will show the set time. The appliance is ready for use.
To reset the correct time of day:
1. Press button repeatedly to select the “Time of
day” function. The relevant pilot lamp will start
flashing. Then proceed as described above.
The time of day can only be reset if no automatic
function (cooking duration or end of cooking
) has been set.
To open the oven door, always hold the handle in
the centre.
This procedure should be repeated with the Grill
function for approximately 5-10 minutes.
Then let the oven cool down. Then dampen a soft
cloth with warm water and a little mild washing-up
liquid and use this to clean the oven cavity.
Before using for the first time, carefully wash the
oven accessories as well.