VEGA VEGASON S 61 - Handbuch (Seite 28)

l Internal check of the electronics
l
Indication of the instrument type, the firmware
as well as the sensor TAGs (sensor desig-
nation)
l Output signal jumps briefly (approx. 10 sec-
onds) to the set fault current
Then the corresponding current is outputted to the
cable (the value corresponds to the actual level as
well as the settings already carried out, e.g. factory
setting).
5 Set up with the indicating
and adjustment module
5.1 Short description
Function/Configuration
The indicating and adjustment module is used for
measured value display, adjustment and diagnosis.
Note:
You will find detailed information on the
adjustment in the operating instructions
manual of the "Indicating and adjustment
module".
5.2 Insert the indicating and adjustment
module
Mounting/dismounting the indicating and ad-
justment module
The indicating and adjustment module can be
inserted into the sensor and removed again at any
time. It is not necessary to interrupt the power
supply.
Proceed as follows:
1 Unscrew the housing cover
2 Place the indicating and adjustment module in
the desired position on the electronics (you can
choose any one of four different positions -
each displaced by 90°)
3 Press the indicating and adjustment module
onto the electronics and turn it to the right until
it snaps in.
4 Screw housing cover with inspection window
tightly back on
Removal is carried out in reverse order.
Fig. 26: Installation of the indicating and adjustment module
5.3 Adjustment system
1.1
2
3
1
Fig. 27: Indicating and adjustment elements
1 LC display
2 Indication of the menu item number
3 Adjustment keys
Key functions
l
[OK] key:
- move to the menu overview
- confirm selected menu
- Edit parameter
-
Save value
28 VEGASON S 61
Set up with the indicating and adjustment module
32944
-02
-070301