WolfVision VZ-8light 3 - Handbuch (Seite 12)

11
The DVI- and RGB-output (#16 and #17) can output signals in the following formats:
- XGA (4:3 - 1024x768 pixels) at 60Hz
- SXGA- (4:3 - 1280x960 pixels) at 60Hz - native image
- WXGA (16:9 Widescreen - 1360x768 pixels) at 60Hz
- WXGA* (16:10 Widescreen - 1280x800 pixels) at 60Hz - native image
- 720p (16:9 Widescreen HD - 1280x720 pixels) at 60Hz - native image
- SVGA (4:3 - 800x600 pixels) at 60Hz
- XGA (4:3 - 1024x768 pixels) at 60Hz
- SXGA- (4:3 - 1280x960 pixels) at 60Hz - native image
- SXGA ( - 1280x1024 pixels) at 60Hz
- SXGA+ (4:3 - 1400x1050 pixels) at 60Hz
- XGA 16:9 (special format for non-HD capable 16:9-Plasma displays) at 60Hz
- WXGA (16:9 Widescreen - 1360x768 pixels) at 60Hz
- WXGA* (16:10 Widescreen - 1280x800 pixels) at 60Hz - native image
- WXGA+ (16:10 Widescreen - 1440x900 pixels) at 60Hz
- 720p (16:9 Widescreen HD - 1280x720 pixels) at 60Hz - native image
Please note that the
Visualizer can not check the possible resolution, if the connected units or the cables* are not
"Plug and Play" compatible. If the Visualizer can not detect the resolution of the connected
device, the output is set to the default of XGA (1280x960)/60Hz.
(*Cables with plug and play compatibility must have a 15-pin plug on both ends with all pins connected, pin 9 is not used).
If you can not use the "Auto resolution" function, you can select the output mode manually in the
on-screen menu of the Visualizer (see page 13).
In order to achieve the best picture quality you must set the outputs of the Visualizer to match
the native resolution of your display unit (e.g. LCD or DLP projector or monitor).
Important: What matters is the native resolution of the projector or monitor, not the maximum
resolution that it can display (in compressed mode). The native resolution is the actual number
of pixels of the built-in LCD display or DLP chip of a projector or monitor. Most LCD or DLP
projectors can also display higher resolutions than their native resolution, but only in
compressed mode and with inferior picture quality.
Do NOT set the output of the Visualizer to a higher standard than the native resolution of
your display unit!
Do not use a higher refresh rate than your monitor or projector can display, otherwise
the monitor or projector can be damaged!
Follow the instructions in the user manual of the connected units.
VZ-8light³
VZ-8plus³
The "Auto resolution" function is activated by default. In this mode the Visualizer contiously
checks which devices are connected to the RGB (#17) and DVI output (#16) and automatically
sets the optimal output mode for each connected device separately.
S -
5:4
Choosing the Correct Output Mode