WolfVision VZ-9plu - Handbuch (Seite 9)

8
Shooting Area Outside of the Working Surface
Eliminating reflections
In order to eliminate reflections (on high gloss photographs
etc.) just turn the light upwards or downwards slightly.
It is also possible to move the document and rotate the camera
head to the center of the desired pick-up area to eliminate
reflections.
Please note that reflections can also be caused by general
room lighting conditions.
Shooting Area on the Working Surface
Close-up adaptor lens
For shooting an object outside of the working surface, the
close up lens (#12) has to be removed. In this case just hinge
the lens away from the camera head. It is impossible to
remove the lens completely from the unit and therefore it can
not get lost.
When using the Visualizer to again record on the working
surface, put the close up lens back to its original position.
Turning the light / flexible viewing angle
In order to enable recordings with illumination outside of the
working surface, the light of the Visualizer can be turned
vertically.
To record at a lower viewing angle than the normal working
position, just fold the arm of the Visualizer as much as
required, turn the camera head and the light to pick up the
desired object.
Image Flip
By turning the camera head to record in front of the Visualizer,
the image will automatically be turned 180 degrees (”image
flip”). This feature is very useful for recording the face of the
presenter or objects hanging on the wall behind the unit.
to infinity to infinity
Turntable
The turntable of the Visualizer allows for horizontal pan shots
when using the Visualizer as a camera to record outside of the
working surface. It is also very useful when two people, sitting
on the same table, alternately work with the unit.
When the unit is delivered, the turntable is unlocked
(see page 16 to lock the turn table).