Festo Линейные модули HMP - Handbuch (Seite 21)

HMP−...−B−...−Z..−...
Festo HMP−...−B−...−Z..−... 0412NH English
21
For rough adjustment of the intermediate
position:
1. Remove the housing cover (A) of linear
module type HMP−...−B−...Ă.
2. Exhaust the linear module and the interĆ
mediate position module.
3. Unscrew both plug connectors 1. Only in
this way can all the fastening screws be
loosened.
4. Swivel the stop lever 6 out to the stop.
5. Unscrew the four or five fastening screws
5 so that the intermediate position modĆ
ule can be shifted.
6. Then shift first of all:
ć the guide tube of the linear module
into the desired intermediate position,
then
ć shift the intermediate position module
until the stop lever brushes against the
shock absorber head, then further over
length X of the shock absorber stroke.
HMP−... 16 20/25 32
Length X 12 mm 18 mm 24 mm
Fig. 8
7. Tighten all the fastening screws 5 and the plug connectors 1 again.
The max. tightening torque can be found in the following table.
Position 5 1
Thread/width across flats M5 / A/F4 M3 / A/F5.5
Tightening torque of the cylinder head screws 5.9 Nm 0.7 Nm
Fig. 9
Fig. 6
(A)
Fig. 7
1
5